Driving in North West and Mid Kent
T 01474 332968 : M 07778 355005 : enquiries@ECPCdrivingschool.co.uk
E.C.P.C Driving School
Show and Tell
Show and Tell—Vehicle Safety Check Questions
At the start of your driving test you’ll be asked two vehicle safety check questions. These are to make sure that you can keep your car’s systems (tyres, washers, wipers, etc) working and safe when you are driving your own car. You need to be able to answer these questions for the car in which you take the test. Here are the questions, with the answers for ECPC’s Vauxhall Corsa cars.
B01 Oil Show - Open the bonnet, identify where you would check the engine oil level and tell me how you would check that the engine has sufficient oil.
Identify dipstick / oil level indicator, describe removal, wipe, insertion and removal to check oil level against the minimum / maximum markers.
B02 Steering Show - Show me / explain how you would check that the power assisted steering is working before starting a journey.
If the steering becomes heavy the system may not be working properly. Before starting a journey a simple check can be made. Turning the steering wheel just after moving off will give an immediate indication that the power assistance is functioning. Easy to steer – it works. Heavy steering – power assistance not working.
B03 Coolant Show - Open the bonnet, identify where you would check the engine coolant level and tell me how you would check that the engine has the correct level.
Identify seam markings on the header tank, and describe how to top up to correct level.
B04 Handbrake Show - Show me how you would check the parking brake (handbrake) for excessive wear, make sure you keep safe control of the vehicle
Apply footbrake while doing this. Demonstrate by applying parking (hand-) brake that resistance increases and it secures the car, if there is excessive wear it will go easily to the end of its working travel.
B05 Washer fluid Tell - Identify where the windscreen washer reservoir is and tell me how you would check the windscreen washer
Identify reservoir and need to fill to check level. Need enough for the journey.
B06 Horn Show - Show me how you would check that the horn is working (off road only).
Check is carried out by using control. Ignition not needed.
B07 Brake fluid Show - Open the bonnet, identify where the brake fluid reservoir is and tell me how you would check that you have a safe level of hydraulic brake fluid.
Identify reservoir, check level against high/low markings. Shake car if hard to see level.
B08 Indicators Show - Show me how you would check that the direction indicators are working.
Turn on hazard warning switch and check functioning of all indicators.
B09 Brake lights Show - Show me how you would check that the brake lights are working on this car. (I can assist you, if you need to switch the ignition on, please don't start the engine)
Ask the examiner to check at the rear that there is a bright red light on each side and one in the middle. Turn the ignition to the normal running position, but don’t start the engine, operate the brake pedal.
B10 Brakes Tell - Tell me how you would check that the brakes are working before starting a journey.
As you set off test that the brakes stop the car. Brakes should feel firm, not spongy or slack. Vehicle should not pull to one side.
B11 Lights Tell - Tell me how you would check that the headlights & tail lights are working. (No need to exit vehicle)
Operate switch, walk round vehicle. Describe size, colour and position (both sides!) of lights. Include rear no. plate lights.
B12 Tyre pressure Tell - Tell me where you would find the information for the recommended tyre pressures for this car and how tyre pressures should be checked.
In manufacturer’s guide, use a reliable pressure gauge, check all five tyres (including the spare), when tyres are cold, remember to refit valve caps.
B13 Tyres Tell - Tell me how you would check the tyres to ensure that they have sufficient tread depth and that their general condition is safe to use on the road.
A couple of millimetres of tread everywhere, and even tread wear. Legal requirement is for a minimum 1.6 mm of tread depth across the central ¾ of the breadth of the tyre and around the entire outer circumference. No cuts or bulges in the sidewalls.
B14 Windscreen Washers Show - Show me how you would clean the front and rear windscreens using the windscreen washer and wipers.
Turn the key to the normal running position. Pull the wiper stalk towards you and hold it a while. Release the stalk, wipers will do 4 more sweeps. Push and hold for rear wash/wipe.
B15 Windscreen Demister Show - Show me how you would set the demister controls to clear all the windows effectively, this should include both front and rear screens.
Switch on the rear screen electric demister. Set air supply to windscreen only and set fan speed and air temperature to high. Switch on air conditioner if necessary to dry the air coming into the car.
B16 Rear fog light Show - Show me how you would switch on the rear fog light(s) and explain when you would use it/them. (No need to exit vehicle, Please don't start the engine.)
Turn the key to the normal running position. Turn on dipped headlights. Press rear fog light button (centre of light switch). Use only when visibility due to fog/spray/snow < 100m.
B17 Headlights Show - Show me how you switch your headlight from dipped to main beam and explain how you would know the main beam is on whilst inside the car and when it should be used
Turn the key to the normal running position. Turn on dipped headlights. Push the indicator stalk away from you. Note that the blue light is on in front of you. Pull or push the stalk to dip. Use on unlit roads when no-one is in front of you.
B18 Head Restraints Tell - Tell me how you make sure your head restraint is correctly adjusted so it provides the best protection in the event of a crash
Make sure the restraint will support your head at the level of the eyes and ears – where the weight is. Adjust up or down by pushing button on the left of the restraint.
B19 Brakes Tell - Tell me how you would know if there was a problem with your anti lock braking system
When turning on the ignition the ABS warning light (amber, near the red handbrake warning) should come on for a few seconds. If it stays on, or comes on when driving, there is a fault. If it never comes on, you don’t have ABS.